1
1
Preparing the Recorder
ModelName: ICD-UX522/UX522F/UX523/UX523F
PartNumber: 4-293-033-11
Recharging the Battery
Recharging the battery using a computer
Insert a rechargeable battery.
Slide and lift the battery compartment lid, insert an NH-AAA rechargeable
battery with correct polarity, and close the lid.
Connect the IC recorder to your computer.
Slide the USB DIRECT slide lever on the back of the IC recorder in the
direction of the arrow, and insert the USB connector into the USB port of a
running computer.
*
1
IC recorder
To USB port of your
computer
Computer
While the battery is charging, “Connecting” and the
battery indicator are displayed in an animation.
Battery indicator
When the battery is fully charged, the battery
indicator will indicate “ .” It takes about 3 hours
and 30 minutes to fully charge an exhausted battery.
*
2
Fully charged indicator
*
1
If the IC recorder cannot be connected to a computer directly, use the supplied USB connection
support cable.
*
2
This is an approximation for the time it takes to charge from no remaining battery power to full
battery power at room temperature. It varies depending on the remaining power and the
condition of the battery. It also takes more time if the temperature of the battery is low, or if the
battery is charged while you are transferring data to the IC recorder.
Continued