Sony ICD-UX512, Руководство по эксплуатации

Страница: 114 / 128

114
GB
Message List
Message Cause/Remedy
HOLD • All the button operations are disabled because the IC recorder is in
the HOLD status to prevent unintentional operations. Slide the
HOLD/POWER switch towards the center to release the IC
recorder from the HOLD status (page 10).
Low Battery • The battery is exhausted. Replace the old LR03 (size AAA)
alkaline battery with a new one. Or charge the rechargeable
battery (page 11) or replace the old rechargeable battery with a
new one.
Memory Card Error • An error occurred while a memory card was being inserted into
the memory card slot. Remove and try inserting it again. If this
message persists, use a new memory card.
Memory Card Not Supported • A memory card that the IC recorder does not support is inserted.
See “About compatible memory cards” on page 36.
Memory Card Locked • The memory card is write-protected. A write-protected memory
card cannot be used with the IC recorder.
Read Only Memory Card • A read-only memory card is inserted. A read-only memory card
cannot be used with the IC recorder.
Memory Card Access
Denied • Since a memory card containing an access control function is
inserted, you cannot use it.
Memory Full • The remaining memory capacity of the IC recorder is insufficient.
Erase some files before recording.
File Full • When there are already the maximum number of files in the
selected folder or the total number of files stored on the IC
recorder has exceeded the maximum, you cannot record a new
file. Erase some files before recording.