ICD-SX750 4-157-612-13(1)
0
GB
Notes
If you start recording with pre-recording
function using the built-in microphones,
a click noise may be recorded when you
press
(record/pause). To record with pre-
recording function, we recommend using an
external microphone.
When the remaining recordable time is less
than 10 seconds, the pre-recording function
is disabled.
When 60 minutes have passed after the
IC recorder entered the standby mode,
the standby mode will be cancelled and
recording stops.
If you stop recording before step 8, sounds
buffered in the memory will not be saved.
To cancel the pre-recording
function
Set “PRE REC” to “OFF” in step 4.
Cutting out Low
Frequency – the LCF
Function
,
/MENU
When you set the LCF (Low Cut Filter)
function to “ON” in the stop or recording
mode, you cut out a frequency of lower
than 200 Hz to reduce the roaring noise
from wind, etc., this helps to record a
sound source more clearly.
The LCF function is set to “OFF” when you
purchase the IC recorder.
