Sony HVR-M25AE, Руководство по эксплуатации

Страница: 55 / 108

Chapter 3 Utilizing the Time Code
55
Ch
ap
te
r
3
U
ti
liz
in
g t
h
e
Time
Cod
e
• To record the time code according to the setting of [TC
RUN], set [TC MAKE] to [PRESET]
(page 79)
.
• If you set the advancement mode to [FREE RUN], the
time code will be updated by the internal clock while
the unit’s power is off. The time code may be delayed
or advanced when you turn on the unit power again,
play back a tape, or set the INPUT SELECT switch to
HDV/DV.
To set the frame mode (For 60i only)
Set [TC FORMAT] in the [TC/UB SET] menu to switch
the frame mode
(page 79)
.
AUTO:
Automatically sets the mode in accordance
with the loaded tape.
If nothing is recorded on the tape, the mode is set to
the non-drop frame mode. If the unit cannot read
the frame mode correctly from the tape, the unit
will use the mode that was set in the last position it
was able to read correctly on the tape. If you
remove the cassette, the mode of the last position it
was able to read correctly is cleared and the mode
is set to the non-drop frame mode. If [TC MAKE]
is set to [PRESET], the mode is also set to the non-
drop frame mode.
DF:
Selects the drop frame mode.
NDF:
Selects the non-drop frame mode.
When you set [60i/50i SEL] in the [OTHERS] menu to
[50i], the unit applies the 50i system specification.
Therefore, the time code generated by the unit during
recording is that of the non-drop frame mode. Even if
60i system signals are input to the HDV/DV jack,
when [60i/50i SEL] in the [OTHERS] menu is set to
[50i], the time code generated by the unit is the non-drop
frame mode, regardless of the [TC FORMAT] setting.
To set the unit to generate the time code in the drop
frame mode, set [60i/50i SEL] to [60i].
Notes
Note