95
Device Settings
C
h
ap
te
r 6
Sys
te
m
A
d
m
in
istr
a
to
r S
e
tti
n
g
s
[Contact Switch] Tab
Configure these settings when you want to control the unit
via contact switch devices connected to the contact switch
connectors on the rear panel of the unit, or when you want
to use the tally lamp control and video input switching
functions for the monitor.
1
Use the
B
and
b
buttons to select the [Contact Switch]
tab.
2
Configure the [Contact Switch 1], [Contact Switch 2],
and [Contact Switch 3] settings.
Specify the function that the contact switch device will
control for each contact switch setting.
The procedure for configuring the [Contact Switch 1],
[Contact Switch 2], and [Contact Switch 3] settings is
the same.
The default setting is [Not Used].
1
Use the
V
and
v
buttons to select the box for the
contact switch setting you want to configure, and
press the ENTER button.
The setting screen for the selected contact switch
appears.
2
Use the
V
and
v
buttons to select the function to
control, and press the ENTER button.
[Not Used]
Disable use of the contact switch device.
[Record Video/Pause]
Control pause and resume functions while
recording videos.
[Record Still]
Capture still images.
[Audio On/Off]
Enable or disable audio output.
[Set Chapter]
Insert a chapter separator without saving a still
image of the recording.
The [Contact Switch] tab appears again.
3
Use the
B
and
b
buttons to select [Advanced], and
press the ENTER button.
The [Advanced] screen appears.
4
Use the
V
and
v
buttons to select the [Timing] box,
and press the ENTER button.
The [Timing] screen appears.
5
Use the
V
and
v
buttons to select the control
timing, and press the ENTER button.
The default setting is [Down Edge].
If [Record Still] is selected as the function to be
controlled, the [State] setting cannot be selected
here.
The pause control of the [Record Video/Pause]
function will not operate immediately after
recording starts. Wait about 5 seconds before
performing the control.
Note
Содержание HVO1000MD
Страница 148: ......