76
[Set Index]
Add an index without saving a still image of the
recording.
To configure contact switch settings
1
Select [Advanced] for the contact switch that will
perform the control, and press the ENTER button.
The [Advanced] settings screen for contact switches
appears.
2
Specify the control timing, select [Apply] and press
the ENTER button.
You can select from [Falling Edge], [Leading Edge],
and [State].
The default setting is [Falling Edge].
[State] cannot be selected when the control item is set
to [Record Still] or [Set Index].
The [Contact Switch] tab appears again.
Password Settings
Configure password settings to prevent unauthorized
changes to the [System Admin Settings].
When password protection is enabled, a password entry
screen appears when [System Admin Settings] is selected
in the [Settings] screen.
The password is not configured under default conditions.
When configuring the password for the first time,
configure the new password in the [Change Password]
screen without entering an old password. Be sure to write
down the password in case you forget it. The [System
Admin Settings] cannot be accessed without the
password. Guard the password securely to maintain
security.
To enable password protection
1
Select [Password Settings] in the [System Admin
Settings] screen, and press the ENTER button.
The [Password Settings] screen appears.
2
Select the password lock box, and press the ENTER
button.
3
Select [Use], and press the ENTER button.
The default setting is [Not Used].
4
Select [Settings], and press the ENTER button.
The configuration is saved.
To change the password
1
Select [Change] in the [Password Settings] screen,
and press the ENTER button.
The [Change Password] screen appears.
2
Configure each setting, select [Apply] and press the
ENTER button.
[Old Password]
Enter the old password.
[New Password]
Enter up to 255 characters for the new password.
Any character that can be entered on the on-screen
keyboard can be used in the password.
Note
Содержание HVO-3300MT
Страница 99: ......
