Sony HT-ST5000, Руководство по эксплуатации

Страница: 68 / 167

68
GB
The wireless multi room function
cannot be used on Sony | Music
Center.

Connect the mobile device to the
same network as that of the system.
The remote control of this system
does not function.

Point the remote control at the
remote control sensor on the main
unit (page 8).

Remove any obstacles in the path
between the remote control and the
system.

Replace both batteries in the remote
control with new ones, if they are
weak.

Make sure you are pressing the
correct button on the remote control.
TV remote control does not work.

This problem might be solved by
enabling the IR repeater function
(page 57).
The Control for HDMI function does
not work properly.

Check the connection with the
system (refer to the supplied Startup
Guide).

Enable the Control for HDMI function
on the TV. For details, refer to the
operating instructions of your TV.

Wait a while, and then try again. If
you unplug the system, it will take a
while before operations can be made.
Wait for 15 seconds or longer, and
then try again.

Make sure the devices connected to
the system support the Control for
HDMI function.

Enable the Control for HDMI function
on the devices connected to the
system. For details, refer to the
operating instructions of your device.

The type and number of devices that
can be controlled by the Control for
HDMI function is restricted by the
HDMI CEC standard as follows:
– Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up to
3 devices
– Playback devices (Blu-ray Disc
player, DVD player, etc.): up to 3
devices (this system uses one of
them)
– Tuner-related devices: up to 4
devices
– Audio system (receiver/
headphone): up to 1 device (used by
this system)
“PRTCT,” “PUSH” and “POWER”
flash alternately in the front panel
display.

Press

(power) to turn off the
system. After the indicator
disappears, disconnect the AC power
cord (mains lead) and make sure
nothing is obstructing the ventilation
holes of the system.
“BT TX” appears in the front panel
display.

Press BLUETOOTH RX/TX on the
remote control to switch [Bluetooth
Mode] to [Receiver]. “BT TX” appears
if [Bluetooth Mode] is set to
[Transmitter] (page 55). When you
press BLUETOOTH RX/TX on the
remote control, [Bluetooth Mode] is
switched to [Receiver] and the
selected input appears in the front
panel display.
Remote Control
Others