masterpage:Left
lename[E:\SEM_Janet\Revision_SF800M\J9050000_2592136121SF800M_GB\2592136121\G
B03CON_HT-SF800M-CEL.fm]
14
GB
model name [HT-SS600/HT-SF800M]
[2-592-136-
12
(1)]
To change the speaker cord
If you want to change the speaker cord, you can
detach the supplied speaker cord from the
connector.
1
Press the connector onto a flat surface.
Make sure that the catcher is facing the flat
surface.
2
Pull the speaker cord from the
connector.
3
Twist the stripped ends of the speaker
cord you want about 10 mm and insert
the speaker cord into the connector.
Make sure that the speaker cord is inserted
according to its polarity : + to + and – to –.
Otherwise the sound will be distorted and
will lack bass.
4
Remove the connector from the flat
surface.
Note
To avoid the speaker cord from coming off the speaker
connector
– do not use a smaller-size speaker cord. We
recommend that you use the AWG#18 to AWG#24
speaker cords.
– use the same speaker cord size for all the speaker
connectors.
– twist the stripped ends of the speaker cords.
– insert the speaker cord completely into the speaker
connector.
Connecting the AC power
cord
Connect the AC power cord to a wall outlet.
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure.
This procedure can also be used to return
settings you have made to their factory defaults.
Use the buttons on the receiver for the operation.
1
Press
?/1
to turn off the receiver.
2
Hold down
?/1
for 5 seconds.
“INITIAL” appears in the display.
The following are reset to their factory
settings.
• All settings in the SET UP, LEVEL and
TONE menus.
• The sound field memorized for each
input and preset station.
• All sound field parameters.
• All preset stations.
• MASTER VOLUME is set to “VOL
MIN”.
catcher
+
–
(+)
(–)
4: Connecting the AC
power cord
To a wall outlet
AC power cord
GB01COV_HT-SF800M-CEL.book Page 14 Monday, March 28, 2005 4:03 PM
