Sony HT-SF2000, Руководство по эксплуатации

Страница: 29 / 68

29 GB
D:\CANNES\SONY_HA\JOB 2007\HT-SS2000\IM_SS2000\Data_CEL\Data_GB\GB03CON_HT-
SF2000-CEL.fm masterpage: Right
Getting Star
ted
[HT-SF2000/HT-SS2000]
3-210-806- 11
(2)
When you select “PHASE”
You can check the phase of each speaker (in
phase/out of phase).
Press V / v repeatedly to select a
speaker, then press to return to
step 2 in “Confirming/saving the
measurement results”.
*
xx
represent a speaker channel
FL Front left
FR Front right
C Center
SL Surround left
SR Surround right
SW Sub woofer
Tip
Depending on the position of the sub woofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
After you have finished
Disconnect the optimizer microphone from the
receiver.
You can use the A. CAL menu to make
settings for the Auto Calibration function to
suit your preference.
Select “8-A. CAL” in the amplifier menus. For
details on adjusting the parameters, see
“Navigating through menus” (page 34) and
“Overview of the menus” (page 35).
x AUTO CAL (Auto Calibration on/
off)
• A.CAL NO
The Auto Calibration function is turned off.
• A.CAL YES
The Auto Calibration function start.
x CAL LOAD (Calibration load)
*
• LOAD YES
Select this when you want to load the saved
Auto Calibration result.
• LOAD NO
Select this when you do not want to load the
saved Auto Calibration result.
* You can select this parameter only when you have
performed the Auto Calibration and saved the
settings.
WARN 43 The distance and position of a sub
woofer cannot be detected. This
may be caused by noise. Try to
perform the Auto Calibration in a
quiet environment.
NO WARN There is no warning information.
Display Explanation
xx
* IN The speaker is in phase.
xx
* OUT The speaker is out of phase. The
“+” and “–” terminals of the
speaker may be connected the
other way around. However,
depending on the speakers,
“
xx
* OUT” appears on the
display even though the speakers
are connected properly. This is
because of the speakers’
specifications. In this case, you
can continue to use the receiver.
Warning code Explanation
A. CAL menu parameters