Sony HT-M2, Руководство по эксплуатации

Страница: 27 / 44

27 GB
T
u
n
e
r Op
era
tio
ns
1
Press TUNER repeatedly (or
press FM or AM) to select the
FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Press or TUNING –.
scans from lower to higher
frequency stations and TUNING – for
scanning higher to lower.
The receiver stops scanning whenever a
station is received.
In case of poor FM stereo
reception
If the FM stereo reception is poor and “ST”
flashes on the display panel, select monaural
audio to lessen the sound distortion.
Press FM MODE repeatedly to select
“MONO”. To return to stereo mode, press
FM MODE repeatedly to select “STEREO”.
You can enter the frequency of a station
directly by using the numeric buttons.
1
Press TUNER repeatedly (or
press FM or AM) to select the
FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Press D.TUNING.
3
Press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1
b
0
b
2
b
5
b
0
Example 2: AM 1,350 kHz
Select 1
b
3
b
5
b
0
Tip
Adjust the direction of the AM loop antenna
(aerial) for optimum reception upon tuning to
an AM station.
4
Press ENTER.
If you cannot tune to a station
“–––.––MHz” or “––––kHz” appears and
then the display panel returns to the current
frequency.
Make sure you have entered the right
frequency. Try repeating steps 2 to 4. If you
still cannot tune to a station, the frequency
may not be in use in your area.
(Latin America and Argentina
models only)
You can change the AM tuning scale to either
9 kHz or 10 kHz.
1
Press TUNER repeatedly (or
press AM) to select AM.
2
Press AMP MENU.
3
Press V / v repeatedly to select
“TUNER”, then press or b .
4
Press V / v repeatedly to select
“AM STEP”, then press or b .
5
Press V / v repeatedly to select
the AM tuning scale you want.
Note
All AM preset stations will be erased when you
change the tuning scale.
Tuning to a station
automatically (Automatic
Tuning)
Tuning to a station directly
(Direct Tuning)
Changing the AM tuning scale