28
US
When you select “DIST INFO” or
“LEVEL INFO”
You can check the speaker distance or speaker
level.
• The measurement result of a speaker will not appear if
the subwoofer does not recognize that the speaker is
connected.
After you have finished
Disconnect the calibration mic from the
subwoofer.
• If you have changed the position of the speakers, Sony
recommends that you perform the Auto Calibration
again in order to enjoy the surround sound.
Deleting the result of the Auto
Calibration
You can delete the result of the Auto Calibration.
If there is no saved data, you cannot delete the
result.
1
Press AMP MENU.
2
Press
x
/
X
repeatedly until “A.CAL
MENU” appears, then press
or
c
.
3
Press
x
/
X
repeatedly to select “A.CAL
CLEAR,” then press
or
c
.
4
Press
x
/
X
to select “YES,” then press
.
The saved result is deleted.
The settings for speaker distance and
speaker level return to their defaults.
Depending on the audio output settings of the
connected component, the sound may output in 2
channel sound format only. In this case, set the
connected component to output the sound in
multi channel sound format (PCM, DTS, Dolby
Digital). For details on audio output settings,
refer to the operating instructions of the
connected component.
Note
Note
Setting up the Sound
Output of the Connected
Component
Содержание HT-IS100
Страница 81: ......
Страница 166: ......
Страница 167: ......
Страница 168: ...Sony Corporation Printed in Malaysia 2 ...