Sony HT-GT1, Руководство по эксплуатации

Страница: 14 / 52

HT-GT1.GB.4-542-874- 12 (1)
14
GB
Installing the speaker system
on a wall
Notes
ˎ
Use screws that are suitable for the
wall material and strength. As a plaster
board wall is especially fragile, attach
the screws securely to a wall stud. Install
the speaker system on a vertical and flat
reinforced area of the wall.
ˎ
Be sure to subcontract the installation
to Sony dealers or licensed contractors
and pay special attention to safety
during the installation.
ˎ
Sony is not responsible for accidents
or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied)
that are suitable for the holes
on the back of the speaker
system.
4 mm
(3/16 in)
More than 25 mm (1 in)
5 mm
(7/32 in)
10 mm
(3/8 in)
Hole on the back of the speaker
system
2
Drive the screws to the wall.
The screws should protrude 6 to
7 mm (approx. 1/4 in) from the wall.
142 mm
(5 5/8 in)
(approx. 1/4 in)
6 to 7 mm
3
Hang the speaker system onto
the screws.
Align the holes on the back of the
speaker system to the screws, then
hang the speaker system onto the
2 screws.