29
GB
C:\Documents and
Settings\pc13\Desktop\JC060000_2662263323DDW880_GB\2662263323\GB03CON_HT-
DDW880-CEL.fm
masterpage: Right
HT-DDW880
2-662-263-
32
(3)
Gettin
g
Sta
rted
5: Preparing the receiver
and the remote
If your receiver has a voltage selector on the
rear panel, check that the voltage selector is set
to the local power supply voltage. If not, use a
screwdriver to set the selector to the correct
position before connecting the AC power cord
to a wall outlet.
Connect the AC power cord to a wall outlet.
Note
Install this system so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1
Press
?
/
1
to turn off the
receiver.
2
Hold down
?
/
1
for 5 seconds.
“PUSH” and “ENTER” appears on the
display alternately.
3
Press MEMORY/ENTER.
After “CLEARING” appears on the
display for a while, “CLEARED”
appears.
The following items are reset to their
factory settings.
• All settings in the LEVEL, TONE,
SUR, TUNER, AUDIO, VIDEO and
SYSTEM menus.
• The sound field memorized for each
input and preset station.
• All sound field parameters.
• All preset stations.
• All index names for inputs and preset
stations.
• MASTER VOLUME is set to “VOL
MIN”.
• Input is set to “DVD”.
Setting the voltage selector
Connecting the AC power cord
VOLTAGE
SELECTOR
120V
220V
240V
SPEAKERS
FRONT B
L
R
L
R
CENTER
SURROUND BACK
FRONT A
R
L
+
–
S
+
–
AC power cord
To the wall outlet
Performing initial setup
operations
AUTO CAL MIC
SPEAKERS
(OFF/A/B/A+B)
PHONES
VIDEO 3 IN/PORTABLE AV IN
VIDEO
L AUDIO R
MEMORY/
ENTER
TUNING
MODE
TUNING
2CH
A.F.D.
MOVIE
MUSIC
MULTI CH IN
MUTING
DISPLAY
INPUT MODE
INPUT SELECTOR
MASTER VOLUME
?/1
1,2
3
GB01COV_HT-DDW880-CEL.book Page 29 Friday, July 21, 2006 11:37 AM
