Sony HKSR-9003, Руководство по эксплуатации

Страница: 75 / 177

Power Saving Mode 75
Chap
ter
3
Ba
s
ic
Ad
jus
tme
nt
s
an
d Set
tings
You can extend battery operation time by putting
the unit into power saving mode, which saves
power during recording and playback by turning
off unnecessary signals and enabling other power
saving features.
Settings related to power saving mode include
“LED” and “TALLY” under SYSTEM Setup
>POWER in the VTR menu
(see page 139) , and
the settings on the <POWER SAVE> page of the
Camera >MAINTENANCE menu
(see page
115) .
As described below, you can also reduce power
consumption by selecting lower output levels and
by turning off the functions of unit circuits that
you are not using.
• Under INPUT SEL in the VTR >AUDIO Setup
menu, turn off all audio inputs. This turns off
the power of the audio input circuits.
• Lower the volume of your earphones.
• Turn off the backlight of the control panel.
• Lower the brightness of the subdisplay
backlight.
• Detach the control panel. (Before doing this,
you can assign basic tape transport functions to
the assignable buttons/switch.)
• Detach the AP-1 (optional) (the same
operations are available on the subdisplay).
• If you need only the camera module and will not
be running the tape, you can put the unit into
standby off mode by doing the following. This
turns the drum drive off.
- Press the FUNC + STOP buttons on the
control panel (see page 21) .
- Set SYSTEM Setup >SERVO >STBY OFF in
the VTR menu to “1sec” (see page 138) .
- With an assignable button/switch to which the
VTR SAVE function is assigned, select
SAVE
(see page 48) .
- Eject the cassette.
• When the HKSR-9001 is installed:
1
Turn HD SDI A/B output off by setting
the ON/OFF switch of the HD SDI OUT
A/B connectors on the rear panel
(page
19) to OFF.
2
Turn the AUX IN input circuits off by
making the following settings: on the
<GENLOCK> page of the Camera
>MAINTENANCE menu, set
REFERENCE to something other than
AUX IN; set audio input to something
other than SDI; set TC REGEN SRC to
something other than AUX IN.
The HKSR-9001 is powered off when
you do both
1
and
2
above.
• Turn off HD SDI OUT MON1 output, HD SDI
OUT MON2 output, and TEST OUT output.
• Power off unneeded accessories, or disconnect
them.
See “VTR Menu Operations” (page 128) and “Basic
Camera Menu Operations” (page 89) for more
information about operations in the VTR and
Camera menus.
Power Saving Operations in the <POWER
SAVE> page of the Camera
>MAINTENANCE menu
MONITOR OUT: Enable or disable monitor
output.
DOWN CONVERTER: Enable or disable VBS/
RM output.
REMOTE: Enable or disable communications
with the RM-B750 or RM-B150.
Power Saving Mode