Sony HKSR-9003, Руководство по эксплуатации

Страница: 54 / 177

Setting the Camera Outputs 54
Chap
ter
3
Ba
s
ic
Ad
jus
tme
nt
s
an
d Set
tings
To apply monitor LUT to the monitor
picture
When MLUT/PBMIX is set to MLUT, the
monitor LUT (ITU-R709) appropriate for
monitoring is applied to the video signals output
from the VF, HD SDI MON1, HD SDI MON2,
and REMOTE connectors. The video output
signals from those connectors are selected on the
<MONITOR OUTPUT> page.
1)
This setting is effective when S-LOG gamma is
applied to the video output signals for recording
intended for postproduction editing.
1) The VBS output signal always becomes the camera
image to which ITU-R709 gamma is applied.
Notes
• The monitor LUT function is enabled when the
optional HKSR-9003 is installed and you are using the
RGB 4:4:4 format.
• If the monitor LUT is activated with 23.98PsF, the
output for viewfinder and monitors is switched to
59.94i. In the case of 24PsF, the output is switched to
50i.
To eliminate this phenomena, change the DOWN
CONVERTER setting on the <POWER SAVE> page
of the MAINTENANCE menu from ACTIVE to PWR
SAVE.
• Some of the paint settings (black, gamma, knee, detail,
matrix, etc.) for the main line are not applied to
monitor LUT.
To monitor the playback picture
You can monitor the on an playback picture can
be confirmed with a external monitor or on the
viewfinder screen.
1)
1)When MLUT/PBMIX is set to MLUT or OFF, the
same gamma as that applied to the main line is applied
to all the outputs. However, the PB and PB MIX
modes can be independently selected for the VF,
MON, and VBS signals.
You can change the PB setting separately for the
VF, MONI, and VBS signals to select their
playback signal output modes.
Note
If the unit is turned off with PB ON, the picture on the
viewfinder/monitor screen is distorted. The normal
picture is restored by turning the unit on or setting PB to
AUTO or OFF.
To compare the playback and camera
pictures
When PB (playback signal output mode) is set to
ON or AUTO, you can set PB MIX to ON to
display the playback picture and the camera
picture in the same screen.
You can change the PB MIX setting separately
for the VF, MONI, and VBS signals to turn
playback signal mixing on and off. When it is
turned on, the playback picture and camera output
are mixed.
You can also use the <PB MIX SETTING> page
of the Camera >SER (OPERATION) menu to
select the playback picture and camera picture
display modes.
MIX TYPE
Select how to display the playback and camera
pictures.
<PB/MON LUT> page
Setting Signal
ON The playback picture is always output.
AUTO Normally, the camera image is output.
When the unit enters playback mode
(PLAY, FF, REW, or REC REVIEW),
the playback picture is automatically
selected.
OFF The camera image is always output
(default).
<PB MIX SETTING> page