Sony HKSR-9003, Руководство по эксплуатации

Страница: 31 / 177

Attaching the Viewfinder 31
Cha
p
te
r 2
P
rep
ar
at
ions
Caution
When the viewfinder is attached, do not leave the unit
with the eyepiece facing the sun. Direct sunlight can
enter through the eyepiece, be focused in the viewfinder
and cause fire.
For details on handling the viewfinder, refer to the
instruction manual for the viewfinder.
1
To attach the viewfinder at a higher
position, loosen the two screws, using
the 2.5-mm wrench stored in the
wrench box
(see page 17) to detach the
viewfinder shoe, and attach it to the
upper position using the upper screw
holes.
To attach it at a lower position, use the
2.5-mm wrench to loosen the three
screws that secure the viewfinder plate,
remove the viewfinder plate, and attach
the viewfinder directly.
2
Fit the viewfinder to the viewfinder
shoe and slide the viewfinder
horizontally.
The viewfinder stopper slides down
automatically.
3
Set the viewfinder to the most
convenient position, tighten the
viewfinder positioning ring (
1
in the
figure below), and connect the
viewfinder cable to the VF connector of
the camera (
2
in the figure below).
To detach the viewfinder
Loosen the viewfinder positioning ring, pull on
the viewfinder stopper, then pull out the
viewfinder by sliding it in the direction opposite
that when attaching.
Attaching the Viewfinder
Viewfinder shoe
Stopper
1
2