Sony HKSR-101, Руководство по эксплуатации

Страница: 31 / 128

Chapt
er
3
P
rep
ar
at
ions
31
3-3 About Reference Sync Signals
3-3-2 Connecting Reference Signals
(Examples for When External Sync Is
Required)
Connect reference signals as explained below, depending
on how you want to use the system.
Connections to record signals from cameras, switchers, signal generators, etc.
In the SYSTEM Setup menu, set REFERENCE >MODE
to “Input”
(see page 56) , and then connect as shown below.
Connections to record using optical-fiber cable
To record using an optical-fiber connection between this
unit and the F23 (F35)+CA-F101 camera, with the
optional HKSR-101 installed in the SRPC-1, the first step
is to synchronize by supplying reference signals from this
unit to the F23 (F35)+CA-F101 over the optical-fiber
cable. Next, output signals from the synchronized F23
(F35)+CA-F101 are input to this unit, replacing the
reference signals of this unit.
If you do not want to input external reference signals to
this unit, set REFERENCE >MODE
(see page 56) in the
SYSTEM Setup menu to “Input”.
When you need to input external reference
signals to this unit
Set REFERENCE >MODE in the SYSTEM Setup menu
to “External”, and set REFERENCE >EXTERNAL to the
appropriate value for the reference signals that you are
using
(see page 56) .
If you want to input an HD tri-level sync signal to the REF
IN HD connector, set REFERENCE >EXTERNAL to
“HD” and make the connections shown below.
HD SDI IN A/B
HD SDI OUT A/B
Reference signals
Camera, switcher, signal
generator, etc.
SRW-1 + SRPC-1
REF IN, GENLOCK IN
In the SYSTEM Setup menu, set
REFERENCE >MODE to “Input.”
(A only or A/B)
(A only or A/B)
REF I N HD
CCU CAMERA
F23/F35 Digital Cinematography
Camera (with CA-F101 Optical
Fiber Camera Adapter)
FC2-PD50/PD250 Optical-Fiber
Cable (optional).
SRW-1 + SRPC-1
+ HKSR-101 (optional)
In the SYSTEM Setup menu, set
REFERENCE >EXTERNAL to “HD”.
Reference signals