23
1-4. Arranging Harness when Removing the HKC-WL50 (Outside Panel Assembly)
When replacing the HKC-WL50 (outside panel assembly) with another one, arrange the harness (DC-OUT-POWER) as described
below.
1. Pass the harness (DC-OUT-POWER) through the clamper again.
2. Place the harness (DC-OUT-POWER) at the back of the DPR-390 board.
Arrange the harness (DC-OUT-POWER) avoiding area A to prevent the following.
This harness arranging is performed to prevent pinching of the following.
•
Pinching the harness when the outside panel is closed.
•
Pinching the harness when the HDLA is installed.
Note
Tip
Clamper
DPR-390 board
Harness (DC-OUT-POWER)
A
Содержание HKC-WL50
Страница 17: ...15 34 Attach the SW 1742 board and then tighten the screw PSW3 x 6 SW 1742 board ...
Страница 24: ...22 13 Attach the rating label to the camera body Rating label ...
Страница 26: ...24 Revision History Date History Contents 2019 3 1st Edition 9 932 686 01 ...
Страница 28: ...HKC WL50 SY J E 9 932 686 01 Sony Corporation Printed in Japan 2019 3 08 2019 ...