46
Preparations
l
AUDIO IN CH1 and CH2 connectors (XLR 3-pin)
and switches
Connect audio signals. An input select switch and
microphone power switch are provided for each channel.
CH1 audio input select switch
Set to the appropriate position according to the equipment
connected to the AUDIO IN CH1 connector.
LINE:
When a line-level (0 dBu) signal source is
connected
FRONT MIC:
When using the microphone connected to
the MIC 1 IN connector
MIC:
When an external microphone is connected
CH2 audio input select switch
Set to the appropriate position according to the equipment
connected to the AUDIO IN CH2 connector.
LINE:
When a line-level (0 dBu) signal source is
connected
AES/EBU:
When a digital audio signal is connected (The
signal must be in synchronization with the camera
output).
MIC:
When an external microphone is connected
Microphone power switches
When a microphone is connected to the corresponding
AUDIO IN connector, set whether or not to supply a power
to the microphone.
+48V:
To supply a power of +48 V
OFF:
Not to supply a power
(No function has been assigned to the lowermost
position.
No power is supplied to the microphone.)
To supply a power of +12 V, modification of the camera is
required.
Preparations
Attaching a Lens
The procedure for attaching a lens to the camera is as
follows:
For information on handling lenses, refer to the lens’
operation manual.
1
Push the lens fixing lever upwards and remove the lens
mount cap from the lens mount.
2
Align the lens’ alignment pin with the notch in the
upper part of the lens mount and insert the lens into the
mount.
3
While supporting the lens, push the lens fixing lever
downwards to secure the lens.
4
Connect the lens cable to the LENS connector.
5
Secure the lens cable with the cable clamp.
Adjusting the Flange Focal Length
Adjustment of the flange focal length
1)
is necessary in the
following situations.
• The first time a lens is attached
• When changing lenses
• When zooming and the focus is not sharp at both
telephoto and wide angle
Note
CH 1
48V
OFF
MIC
LINE
48V
OFF
MIC
LINE
AES/EBU
FRONT MIC
AUDIO IN
CH 2
CH2 audio input select switch
CH1 audio input select switch
Microphone power switches
AUDIO IN CH1 connector
AUDIO IN CH2 connector
1,3
4
2
5
