30
Searching for the starting point
END SEARCH will not work once you
eject the cassette after you have recorded on
the tape.
Make sure that the POWER switch is set to
TAPE.
Touch
t
.
The last scene of the most recent
recording is played back for about 5
seconds, and the camcorder enters the
standby mode at the point where the last
recording has finished.
b
Notes
• END SEARCH will not work correctly when
there is a blank section between recorded
sections on the tape.
z
Tips
• You can also select [END SEARCH] from the
menu. When the POWER switch is set to
PLAY/EDIT. select the [END SEARCH] short-
cut in Personal Menu (p. 36).
You can view about 2 seconds of the scene
recorded just before you stopped the tape.
Make sure that the POWER switch is set to
TAPE.
Touch
t
.
The last 2 seconds (approx.) of the most
recently recorded scene are played back.
Then, your camcorder is set to standby.
Searching for the last scene of
the most recent recording (END
SEARCH)
END SEARCH
EXECUTING
CANCEL
0:00:00
1
60min
Touch here to cancel the operation.
Reviewing the most recently
recorded scenes (Rec review)
0:00:00
STBY
60min
