Saving and Loading Lens Files
147
Chapt
er
7
Sa
ving and
L
oadi
ng Us
er Set
ting Dat
a
2
Select Lens Store Mem or Lens Store
SxS, and press the MENU knob.
Select Lens Store Mem if you want to save
the data in the camcorder’s internal memory,
and select Lens Store SxS if you want to save
the data on an SxS memory card.
3
To execute the save, select [Execute],
and then press the MENU knob.
To cancel the save, select [Cancel], and
then press the MENU knob.
If you select [Execute], a list box of lens file
number appears. File numbers where “No
File” is displayed are empty file numbers.
4
Select the file number under which you
want to save the data, and then press the
MENU knob.
A confirmation message appears.
5
To execute the save, select [Execute],
and then press the MENU knob.
To cancel the save, select [Cancel], and
then press the MENU knob.
If you selected Lens Store SxS in step
2
, the
ACCESS lamp lights when you execute the
save (in blue on the right-side panel and in
orange in the card slot section).
When the data has been saved to the SxS
memory card, a completion message appears
and the ACCESS lamp goes out.
To load a lens file from an SxS memory card,
insert the SxS memory card into a memory card
slot, and then proceed as follows.
See “Basic Setup Menu Operations” (page 97) for
information about menu operations.
1
Select FILE >Lens in the setup menu.
2
Select Lens Recall Mem or Lens Recall
SxS, and press the MENU knob.
Select Lens Recall Mem if you want to load
the file from the camcorder’s internal
memory, and select Lens Recall SxS if you
want to load the file from an SxS memory
card.
3
To execute the load, select [Execute],
and then press the MENU knob.
To cancel the load, select [Cancel], and
then press the MENU knob.
If you select [Execute], a list box of lens files
appears. File numbers where “No File” is
displayed are empty file numbers.
4
Select the desired file number, and then
press the MENU knob.
A confirmation message appears.
5
To execute the load, select [Execute],
and then press the MENU knob.
To cancel the load, select [Cancel], and
then press the MENU knob.
If you selected Lens Recall SxS in step
2
, the
ACCESS lamp lights when you execute the
load (in blue on the right-side panel and in
orange in the card slot section).
When the specified lens file has been loaded
from the SxS memory card, a completion
message appears and the ACCESS lamp goes
out.
When you are using a lens that support serial
communication, you can set up the camcorder by
automatically loading the lens file that
corresponds to the lens settings (Lens Auto Recall
function).
To use the Lens Auto Recall function, set FILE
>Lens >Lens Auto Recall in the setup menu to
one of the following.
On:
Load the lens file that corresponds to the
model name.
Off:
Do not use the Lens Auto Recall function.
Serial Number:
Load the lens file that
corresponds to the model name and serial
number (when the lens supports
communication of the serial number).
If the lens does not support communication of the
serial number, both settings load the lens file that
corresponds to the model name.
Loading Lens Files
Loading Lens Files Automatically
