Sony FWD-32B1, Руководство по эксплуатации

Страница: 76 / 289

30
GB
Adv
a
nc
e
d
S
e
tu
p
Sync Mode Set the type of signal input at pin 13 of the HD15 (RGB/COMPONENT) IN
connector.
• “Sync Mode” is available only when analog RGB signal is input to HD15
connector.
• There are some inputs for which only “H/Comp” can be selected. In this case,
input horizontal/vertical synchronization signals through the pin 13 or 14 of the
connectors.
• This display does not support the three value sync format of 576/60p.
• When “Video” is selected in “Sync Mode”, you can only set the 575/50i and 480/
60i signals.
H/Comp
Sets a horizontal synchronous signal input.
Video Sets a video signal input.
RGB/YUV Sets the type of signal for a piece of video equipment or PC connected to the HD15
(RGB/COMPONENT) connector of the display.
Auto Automatically sets whether an analog RGB signal or a component signal is input
from a connected device.
RGB Set when an analog RGB signal is input from a connected device.
YUV Set when a component signal is input from a connected device.
Color System
Select “NTSC” or “PAL” to set the color system. Select “Auto” to set the color
system automatically.
“Color System” is available when the input signal is from a VIDEO IN connector
(Composite video signal).
RGB Signal Set whether a 1280 × 720/60, 720 × 480/60 or 1920 × 1080/60 RGB input signal is
displayed as a PC signal or a video signal.
Select “HD15”, “DVI” or “HDMI” according to the input connector, and then
select “PC” or “Video” for each. The following input connectors are valid for each
setting “HD15”, “DVI” or “HDMI”.
“HD15”: HD15 (RGB/COMPONENT) IN connector
“DVI”: DVI IN connector
“HDMI”: HDMI IN connector
HD15/DVI/HDMI
Screen Saver This is a setting to prevent or reduce screen burn or after-image that can occur by
long periods of screen display of the same image.
Off Disables the “Screen Saver” setting.
All White Displays an all-white screen. (Stops automatically after about 30 minutes and the
display enters standby mode.)
Sweep Scrolls a white bar over the screen.
Standby Turns on a screensaver for the time set in “Timer Setting” in standby (page 10).
(The display is blank during screensaver operation.) When the set time has passed,
the display returns to the regular standby state.
Menu Position
(FWD-55B2/46B2/42B2) Changes the menu screen's orientation to match the display's installation
orientation.
Landscape Show the menu screen horizontally.
Portrait Show the menu screen vertically.
Menu Function and operation
Notes
Note