3
Locations and Functions of Parts
Front Panel
1
STANDBY button
Press to set the unit to standby mode.
2
HALT button
Press to stop operation in an emergency.
3
Power switch
Set to
I
to supply power to the FVS-1000.
Film mount table
(See page 5.)
1
STANDBY button
2
HALT button
3
Power switch
Control panel
(See page 6.)
Signal processing block
Notes
• If a front or rear door is open, an interlock switch
will be set to OFF, and power is not supplied to the
film transport block even if the power switch is set
to
I
.
• These switches do not turn ON or OFF the power to
the optional devices installed in the unit. To control
the power supply to the installed devices, install a
breaker or switch for the devices.