12
The supplied whip antennas can be attached to the front
or rear panel of the unit.
Front panel attachment
1
Insert commercially available antenna mounts with
BNC connectors into the front panel, and secure them
with hexagon nuts (14 mm).
You can also attach the antennas so that the hexagon nuts
are located on the front side of the front panel.
If you have trouble securing the hexagon nuts on the back
side of the front panel, insert the antenna mounts with
BNC connectors into the front panel from the back side,
and secure the nuts on the front side.
2
Attach the supplied whip antennas.
3
Use commercially available BNC cables (50
Ω
,
60 cm or longer) to connect the antenna mounts with
BNC connectors to the ANTENNA a/b IN connectors
on the rear panel of the unit.
Rear panel attachment
Attach the supplied whip antennas to the ANTENNA a/b
IN connectors on the rear panel.
Connection Example of Word Clock
and Audio
For digital audio output to be performed correctly, it is
necessary to connect a device incorporating a sampling
rate converter to the DIGITAL OUT connector of the
receiver or input a master word clock signal to the WORD
SYNC IN connector of the receiver and perform
synchronization.
There are the following two types of system for inputting
a master word clock signal to perform synchronization.
If the number of connected devices is high, we do not
recommend cascade connections. We recommend using a
word clock divider.
Synchronization system example 1
This system connects the master word clock signal in
cascade via the WORD SYNC OUT connector of this
device.
Set the 75
Ω
termination switch of only the DWR-R03D
unit at the end of the cascade connection to ON.
Note
Antenna mount with
BNC connector
Tooth lock washer
Hexagon nut
Whip antenna
(supplied)
Note
Whip antenna
(supplied)
