77
Set
tings
a
nd
Adj
u
st
m
e
nt
s
Note
If you operate the player while the picture is being
stored in memory, the player will fail to store the
picture.
◆
BLACK LEVEL
Selects the black level (setup level) for the
video (NTSC) signals output from the jacks
other than COMPONENT VIDEO OUT.
Note
This does not work with PAL format discs.
◆
BLACK LEVEL (COMPONENT OUT)
Selects the black level (setup level) for the
video (NTSC) signals output from the
COMPONENT VIDEO OUT jacks. You
cannot select this when “COMPONENT
OUT” is set to “PROGRESSIVE” (see
below).
Note
This does not work with PAL format discs.
◆
COMPONENT OUT
Selects the type of signal output from the
COMPONENT VIDEO OUT jacks when the
COMPONENT VIDEO OUT/SCAN
SELECT switch on the rear panel of the
player is set to SELECTABLE. See page 89
for more information about the different
types.
About the COMPONENT VIDEO OUT/SCAN
SELECT switch
The COMPONENT VIDEO OUT/SCAN
SELECT switch on the rear panel of the
player selects the signal output from the
COMPONENT VIDEO OUT jacks:
interlace, progressive or selectable. The
switch takes priority over the setting made in
“COMPONENT OUT.”
To switch the video signal format
If you have selected “PROGRESSIVE” for a
TV that does not accept signals in progressive
signals, or if the software’s video signals are
not suited for progressive video signal
conversion, view the image in Interlace
format.
1
Set the COMPONENT VIDEO OUT/
SCAN SELECT switch on the rear panel
of the player to INTERLACE.
2
Set “COMPONENT OUT” to
“INTERLACE.”
3
Reset the COMPONENT VIDEO OUT/
SCAN SELECT switch to
SELECTABLE.
Normally leave the switch in this position
when using the COMPONENT VIDEO
OUT jacks.
Notes
• When you set “LINE” to “RGB” (page 78), you
cannot select “INTERLACE” or
“PROGRESSIVE.”
OFF
Sets the black level of the
output signal to the standard
level. Normally select this
position.
ON
Raises the standard black level.
Use this setting when the
picture appears too dark.
OFF
Sets the black level of the
output signal to the standard
level. Normally select this
position.
ON
Raises the standard black level.
Use this setting when the
picture appears too dark.
PICTURE
MEMORY
INTERLACE
Select this when you are
connected to a standard
(interlace format) TV.
PROGRESSIVE
Select this when you have
a TV that can accept
progressive signals.
OFF
The player outputs no
component video signals.
,
continued
