4-270-383-
11
(1)
©2011 Sony Corporation
Printed in Thailand
DR-AS22iP
Stereo Headset
Operating Instructions
Manual de instrucciones
Precautions
High volume may affect your hearing.
For traffic safety, do not use while
driving or cycling.
Do not leave the stereo headphones in a location
subject to direct sunlight, heat or moisture.
Do not wash the headphones.
Though this headphones is water resistant design,
avoid exposing the headphones to excessive water or
sweat. Water or sweat entering the headphones may
damage them. If the sound from the headphones
becomes low or stops, leave the headphones to dry
out.
Note on static electricity
Static electricity accumulated in the body may cause
mild tingling in your ears.
To minimise the effect, wear clothes made from natural
materials.
Compatible iPod/iPhone models
You can use the unit with only the following models
supporting remote control. Update your iPod, iPhone
or iPad to the latest software before use. In the
Operating Instructions, iPod, iPhone and iPad are
collectively described as “iPod” except in special cases.
iPod touch 4th generation
iPod touch 3rd generation
iPod touch 2nd generation
iPod nano 6th generation
iPod nano 5th generation (video camera)
iPod nano 4th generation (video)
iPod classic 120GB 160GB (2009)
iPod shuffle 4th generation
iPod shuffle 3rd generation
iPhone 4
iPhone 3GS
iPad 2
iPad
On copyright
iPhone
®
, iPod
®
, iPod classic
®
, iPod nano
®
, iPod
shuffle
®
, and iPod touch
®
are trademarks of Apple
Inc., registered in the U.S. and other countries. iPad
®
is
a trademark of Apple Inc.
“Made for iPod,” “Made for iPhone,” and “Made for
iPad” mean that an electronic accessory has been
designed to connect specifically to iPod, iPhone, or
iPad, respectively, and has been certified by the
developer to meet Apple performance standards. Apple
is not responsible for the operation of this device or its
compliance with safety and regulatory standards.
Using the Center button
Plays/pauses a track of the connected iPod product
with a single press. Skips to the next track with a double
press. Skips to the previous track with a triple press.
Starts the “VoiceOver*” feature with a long press (if
available).
Press once to answer the call. Press again to end. Hold
down for about two seconds to reject an incoming call.
When you let go, two low beeps confirm the call was
rejected.
* Availability of the “VoiceOver” feature depends on
iPod and its software version.
Note
Be careful not to unintentionally press any buttons
when you carry your iPod with this unit connected.
Specifications
Headphones
Type:
Open, dynamic
Driver unit:
13.5 mm, dome type (CCAW adopted)
Power handling capacity:
50 mW (IEC*)
Impedance:
16 Ω at 1 kHz
Sensitivity:
104 dB/mW
Frequency response:
17 Hz – 22,000 Hz
Cord:
1.2 m (47
1
/
4
in), Y-type
Plug:
Four-conductor gold-plated L-shaped stereo
mini plug for iPod and iPhone with remote function
Mass:
Approx. 12 g (0.43 oz) (without cord)
Microphone
Open circuit voltage level:
– 42 dB (0 dB=1 V/Pa)
Supplied accessory
Clip (1)
* IEC = International Electrotechnical Commission
Design and specifications are subject to change without
notice.
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
How to use
Clip
English
Stereo headset
*
Center button
Volume –
Microphone
* There is a tactile dot
beside .
