Sony DMX-R100, Руководство по эксплуатации

Страница: 26 / 134

26
Chapter 2 Locations and Functions of Parts and Controls
Chapter 2 Locations and Functions of Parts and Controls
Locations and Functions of Parts and Controls
Automation Panel
TC AUTOMATION SNAPSHOT
SELECT MACHINE
1 2 3
A B SAFE
ABS
HOURS MINUTES SECONDS FRAMES SNAPSHOT
TRIM OFF
TO LINK DELETE SETUP
STORE RECALL UNDO
4 5 6
SET LOCATE BARS SET LTC
7 8 9
SHUTTLE
– +
4 5 6
1 2 3
CLEAR
0
ENTER
1
SELECT MACHINE
buttons
2
TC AUTOMATION
buttons
3 Timecode display
window
4 Timecode input
section
5 SNAPSHOT
buttons
6 SNAPSHOT display
window
7
SNAPSHOT SET
button
8
Transport control
keys
9 Jog dial section
0
Ten key pad
1 SELECT MACHINE buttons
Selects the device to be controlled using the transport
control keys. You can assign the device to a controller
port on the MACHINE CONTROL window (page 80)
on the display.
2
TC (timecode) AUTOMATION buttons
The master dynamic automation functions are
controlled by this section.
SAFE button: At the time when the timecode stops,
and automation data is completed. With this button set
to off, the previous automation data is updated when
the timecode stops. With this button lit (ON), the
previous automation data is not processed to inhibit
the update of the automation data.
Switching this button will be useful in the following
cases:
• If you perform an undesired operation as a mistake,
the automation data now processed can be cancelled
by setting the SAFE button to ON before you stop the
tape recorder.
• If you perform an operation with the SAFE button set
ON, the operation now performed can be stored in an
automation data by setting the SAFE button to OFF
before you stop the tape recorder.
Note
In AUDITION mode, the SAFE button functions in a
different manner; an undesired operation performed
cannot be cancelled by the SAFE button.
For further information about the SAFE button in
AUDITION mode, see page 78.