Sony Digital betacam DVW-970, Руководство по эксплуатации

Страница: 145 / 162

145
Menu List
Ap
pend
ix
e
s
MAINTENANCE Menu
The following table lists and describes the items in the
MAINTENANCE menu.
When the setting range in the Settings column is
surrounded by parentheses ( ), the setup value is a relative
value. The setting range shown on the menu screen may
differ from what is shown in the manual.
No. Page Item Settings Default Description
M01 WHT SHADING WHT SHAD CH
SEL R/G/B/TEST R Selects the channel adjusted by this menu. If
TEST is selected, the setting is the same as
the setting of TEST OUT SELECT.
TEST OUT SELECT ENC/R/G/B ENC Selects the signal output to the TEST OUT
connector.
R/G/B WHT H SAW (–99 to +99) 0 Adjusts the H Saw white shading
compensation.
R/G/B WHT H PARA (–99 to +99) 0 Adjusts the H Parabola white shading
compensation.
R/G/B WHT V SAW (–99 to +99) 0 Adjusts the V Saw white shading
compensation.
R/G/B WHT V PARA (–99 to +99) 0 Adjusts the V Parabola white shading
compensation.
WHITE SAW/PARA OFF/ON ON Turns white shading Saw and Parabola
compensation on and off.
M02 BLK SHADING BLK SHAD CH SEL R/G/B/TEST R Selects the channel adjusted by this menu. If
TEST is selected, the setting is the same as
the setting of TEST OUT SELECT.
TEST OUT SELECT ENC/R/G/B ENC Selects the signal output to the TEST OUT
connector.
R/G/B BLK H SAW (–99 to +99) 0 For the H Saw black shading compensation
R/G/B BLK H PARA (–99 to +99) 0 For the H Parabola black shading
compensation
R/G/B BLK V SAW (–99 to +99) 0 For the V Saw black shading compensation
R/G/B BLK V PARA (–99 to +99) 0 For the V Parabola black shading
compensation
BLACK SAW/PARA OFF/ON ON Turns black shading Saw and Parabola
compensation on and off.
MASTER BLACK (–99 to +99) 0 Adjusts the master black level.
MASTER
GAIN(TMP) –3/0/3/6/9/12/18/
24/30/36/42/48 dB 0 dB Temporarily adjusts the master gain value.
M03 LEVEL ADJ ENC VIDEO LEVEL (–99 to +99) 0 Adjusts the encoder video level.
RGB LEVEL (–99 to +99) 0 Adjusts the R/G/B video level.
TEST OUT SELECT ENC/R/G/B ENC Selects the signal output to the TEST OUT
connector.
H BLANKING
WIDTH (–99 to +99) 0 Adjusts the H blanking width.