T
uner
55
GB
Other operations
To change the AM tuning interval
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While touching
.
on the unit, press
?/1
on the unit. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the same
procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode (page 68).
Tips
• The preset stations are retained for about a half day
even if you disconnect the power cord or if a power
failure occurs.
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 54).
1
Press FU or – (or touch
TUNER/BAND on the unit) repeatedly
to select “TUNER FM” or “TUNER AM”.
2
Press or – repeatedly to
select the desired preset station.
Tip
You can also select the desired preset station by
pressing the number buttons and ENTER in step 2.
To
Do this
Tune in a station
with a weak signal
Follow the procedure described
in “Manual tuning preset”
(page 54).
Set another station
to the existing
preset number
Start over from step 1. After
step 4, press
M
or
m
repeatedly
to select the preset number you
want to store the other station.
Cancel presetting
Press MENU in step 3 or 4.
Listening to the radio
Frequency
Preset number
continued
