1-6
DCR-SR190E/SR200/SR200C/SR200E/SR290E/SR300/SR300C/SR300E_L2
ENGLISH
JAPANESE
ENGLISH
JAPANESE
1-4. PRECAUTION ON REPLACING THE VC-492 BOARD
DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Refer to Service Manual ADJ, and perform “DESTINATION DATA WRITE”.
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Refer to Service Manual ADJ, and perform “USB SERIAL No. INPUT”.
1-5. USING SERVICE JIG
Connect the extension cable between CN4008 on the DA-042 board and CN1005 on the VC-492 board.
CN4008
CN1005
DA-042 board (side B)
VC-492 board (side B)
Extension cable (100P)
1-6. PROCESS AFTER FIXING FLASH ERROR
When “FLASH error” (Self-diagnosis Code E : 91 : 01) occurs, to prevent any abnormal situation caused by high voltage, setting of the flash
is changed automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. Flash error code can be initialized by execution of “Clear All record-data”.
Note:
For “Clear All record-data”, refer to Service Manual, ADJ (“7. Record Data” of “2-2. SERVICE MODE”).
Ver. 1.2 2007.06
