Sony DAV-DZ340K, Руководство по эксплуатации

Страница: 66 / 80

66
GB
Troubleshooting
If you experience any of the following difficulties while using the system, use this troubleshooting
guide to help remedy the problem before requesting repairs. Should any problem persist, consult your
nearest Sony dealer.
Note that if service personnel changes some parts during repair, these parts may be retained.
General
Picture
Symptom Problems and solutions
The power is not turned on. • Check that the AC power cord (mains lead) is connected securely.
The remote does not function. • The distance between the remote and the unit is too far.
• The batteries in the remote are weak.
The system does not work
normally. • Disconnect the AC power cord (mains lead) from the wall outlet (mains), then
reconnect after several minutes.
• Perform the following procedure (noting that the system parameters, such as
preset stations, return to the default settings):
1
Press " / 1 to turn on the system.
2 Press
N
, FUNCTION, and
"
/
1
on the unit at the same time. “RESET”
appears in the front panel display.
Symptom Problems and solutions
There is no picture. • The video input on your TV is not set so that you can view pictures from the
system.
• Check the output method on your system.
There is no picture when you
make an HDMI cable
connection. • The unit is connected to an input device that is not HDCP (High-bandwidth
Digital Content Protection) compliant.
• If the HDMI OUT jack is used for video output, change the type of video signal
output from the HDMI OUT jack (page 59).
Connect your TV and the unit using a video jack other than HDMI OUT, and
switch your TV’s input to the connected video input so that you can see the on-
screen displays. Change the type of video signal output from the HDMI OUT
jack, and switch your TV’s input back to HDMI. If the picture still does not
appear, repeat the Steps and try other options.
There is no picture when you
make a component video cable
connection (DAV-DZ640K/
DAV-DZ840K/DAV-DZ940K
only). • You have set progressive format but your TV cannot accept the signal in
progressive format. In this case, return the setting to interlace format (the
default setting) (pages 30, 58).
• You have set [PROGRESSIVE (COMPONENT OUT)] in [VIDEO SETUP] to
[ON] (page 58) even though your TV cannot accept the progressive signal. In
this case, disconnect the HDMI cable from the unit and then set to [OFF].
• Even if your TV is compatible with progressive format (525p/625p) signals, the
image may be affected when you set progressive format. In this case, return the
setting to interlace format (the default setting) (pages 30, 58).
Picture noise appears. • If the picture output from your system goes through your VCR to get to your
TV, the copy-protection signal applied to some DVD programs could affect
picture quality. Connect the unit directly to your TV.
An image is not displayed on the
entire TV screen. • Check the setting of [TV TYPE] in [VIDEO SETUP] (page 58).
• The aspect ratio on the disc is fixed.