2-6
DSC-W150/W170_L2
2-3. BARRIER ASSY REPLACING METHOD
5
Utilizing a concave portion of the Barrier Assy, insert the edge of nippers into the side surface to make a cut in and wind it up
to peel about 2/3 (about 10mm; approximately second convex).
Note:
Mask the second lens barrel to prevent damage.
6
Wind a rubber around the remaining part of the Ornamental Ring (A) and apply torque to peel the part that remains inside and
at the hem.
7
Disengage three claws, and remove the Barrier Assy.
Concave
Second lens barrel
Rubber
Ornamental Ring (A)
Convex
10mm
A
B
Barrier Assy
Removal
1
Turn on the power switch and extend the lens up to the TELE end.
2
Detach the battery.
3
Insert the edge of nippers from the inner diameter into
A
or
B
of the Ornamental Ring (A) to make a cut in till the outside.
4
Pinch either of the parted surfaces and wind it up to peel the flat surface on the objective side.
Note:
Applying a load to the lens barrel could affect the lens zoom-in operation. Do not apply a load to the lens barrel.
Claws
