Sony Cyber-shot DSC-T20, Руководство по обслуживанию

Страница: 13 / 54

2-1
2. DISASSEMBLY
DSC-T20/T25_L2
NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, don’t pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, don’t press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
DISCHARGING OF THE ST-163 BOARD’S CHARGING CAPACITOR (C901)
The charging capacitor (C901) of the ST-163 board is charged
up to the maximum 300 V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand. The electric shock is caused by
the charged voltage which is kept without discharging when the
main power of the unit is simply turned off. Therefore, the
remaining voltage must be discharged as described below.
Preparing the Short Jig
As the discharging location is in depths, the short jig may touch
to the opening of frame.
Expose the tip of resistor of 1k
Ω
/1 W (1-215-869-11) by 1mm
and insulate the rest of it with insulation tape.
1 k
Ω
/1 W
Wrap insulating tape.
to about 1mm to about 1mm
Note: High-voltage cautions
Discharging the Capacitor
Short-circuit between the two points
with the short jig about 10 seconds.
To avoid the spark with the metal plate,
wrap the short jig with the insulation tape.
R:1 k
Ω
/1 W
(Part code: 1-215-869-11)
Charging
Capacitor