DSC-HX10/HX10V_L2
1-10
1-9. ORNAMENTAL RING A OR BARRIER ASSY REPLACING METHOD
Installation
2
3
5
A
Removal
Ornamental Ring A
Ornamental Ring A
Solvent
Tweezers
Barrier Assy
Barrier Tapes
Barrier Tapes
Claws
Barrier Assy
Barrier Assy
Claws
Lever
Hole
Dent
Dent
1
2
3
4
Turn on the power and pull out the lens to set it in the TELE end state.
Remove the battery.
Apply alcohol to two gaps
A
of the Ornamental Ring A with tweezers or a fine-tipped stick as shown in the figure below.
Turn the Ornamental Ring A clockwise and counterclockwise to detach it.
Release the four claws to detach the Barrier Assy.
Attach two Barrier Tapes so that the end of each tape comes to the dent.
Note: Attach Barrier Tapes carefully so that they do not wrinkle.
Attach the Ornamental Ring A and push it gently.
1
Attach the Barrier Assy while inserting the lever into the hole and locking the four claws.
1G-2G Lens
Projection
Mark A
Mark B
Mark C
Groove
Projection
5ETGYU
Washer
Washer
2
1
3
Projection
Detach the 1G-2G Lens as little as possible.
If it is detached, install the washers with their projections set to the original positions.
When attaching the 1G-2G Lens, match the projection of the 1G-2G Lens with the groove
near the mark A and then tighten three screws in the order of mark A
ψ
mark B
ψ
mark C.
Naruto Gear Lubricated
Assy
(A-1802-347-A)
Hole
Fine-tipped screwdriver.
(or thin stick such as bamboo skewer)
Fix with bond or
equivalent.
Prepare a
Naruto Gear Lubricated Assy
(
A-1802-347-A
) and a fine-tipped screwdriver (or thin stick such as
bamboo skewer). Insert a fine-tipped screwdriver (or thin stick such as bamboo skewer) into the Naruto Gear hole
and fix the Naruto Gear and the screwdriver with bond or equivalent.
Creation of Naruto Gear jig
Note:
Handling of 1G-2G Lens and washers
