1-1
DSC-F828
SECTION 1
SERVICE NOTE
1-1. NOTE FOR REPAIR
1 k
Ω
/1 W
Wrap insulating tape.
Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
Cut and remove the part of gilt
which comes off at the point.
(Take care that there are
some pieces of gilt left inside)
When remove a connector, don't pull at wire of connector.
Be in danger of the snapping of a wire.
When installing a connector, don't press down at wire of connector.
Be in danger of the snapping of a wire.
DD-204
DD-204 board
Short jig
(1k
Ω
/1W)
1-2. DISCHARGING OF THE FLASH UNIT’S CHARGING CAPACITOR
The charging capacitor of the FLASH unit is charged up to the maximum 300 V potential.
There is a danger of electric shock by this high voltage when the capacitor is handled by hand. The electric shock is caused by the charged
voltage which is kept without discharging when the main power of the DSC-F828 is simply turned off. Therefore, the remaining voltage
must be discharged as described below.
1-2-1. Preparing the Short Jig
To preparing the short jig. a small clip is attached to each end of a
resistor of 1 k
Ω
/1 W (1-215-869-11)
Wrap insulating tape fully around the leads of the resistor to prevent
electrical shock.
1-2-2. Discharging the Capacitor
Short circuits between the positive and the negative terminals of
charged capacitor with the short jig about 10 seconds.
Содержание Cyber-shot DSC-F828
Страница 7: ...DSC F828 8 Sony EMCS Co 2003L1600 1 2003 12 Published by DI CS Strategy Div 9 876 279 41 ...
Страница 217: ...Schematic diagrams of the SY 096 board are not shown Pages from 4 25 to 4 44 are not shown ...
Страница 241: ...DSC F828 100 Sony EMCS Co 2004D1600 1 2004 4 Published by DI Technical Support Section 9 876 279 31 ...
Страница 287: ... 44E AF ILLUMINATION FRAME DSC F828 Take a copy of AF ILLUMINATION FRAME with a clear sheet for use ...