Accessory List
Please verify that the package includes the following accessories with the CRX1650L when
unpacking.
If any of these items appears to be missing or damaged, please contact your supplier.
• CRX1650L drive
• AC power cord
• i.LINK cable (6 pin-6 pin)
• A ferrite clamp for the i.LINK cable
• Software Quick Start Guide
• CRX1650L User’s Guide
• Software CD-ROM
• Quick Start Guide
• Warranty Card
Note
To guard against possible loss or damage, be sure to make a backup copy of the provided software CD-ROM on a
CD-R disc or other media. The software CD-ROM is not sold separately.
Before Connecting the i.LINK Cable to the Computer
Attach the ferrite clamp to the Computer end of the i.LINK cable. Position the ferrite clamp
as shown in the illustration below, and then secure the ferrite clamp by closing it until you
hear a click.
Note
To satisfy radio-frequency interference suppression standards, be sure to install the ferrite clamp correctly. It
reduces the possibility interference with other devices.
2001 Sony Corporation
Printed in Malaysia
CRX1650L-A2
CRX1650L
User’s Guide
CD-R/RW Drive Unit
4-657-237-11(1)
Please refer to this manual together with the “i.LINK Interface CD-R/RW Drive User’s Guide” in the attached
Software CD-ROM, which carries more detailed information.
To computer
Approximately 8 cm
Safety Regulations
WARNING
Any changes or modifications not expressly approved in this manual could void your
authority to operate this equipment.
To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid
electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
CAUTION
The laser beam in this CRX1650L is harmful to the eyes. Do not attempt to disassemble the
cabinet. Refer servicing to qualified personnel only. The use of optical instruments with this
product will increase eye hazard. The use of controls or adjustments or performance of
procedures other than those specified herein may result in hazardous radiation.
This label is located on the drive unit’s internal chassis.
Dieses Etikett befindet sich auf dem inneren Chassis des Laufwerkes.
DANGER
INVISIBLE LASER RADIATION WHEN OPEN.
AVIOD DIRECT EXPOSIRE TO BEAM
VORSICHT
UNSICHTBARE LASERSTRAHLUNG. WENN ABDECKUNG
GEOFFNET
NICHT DEMSTRAHL AUSSETZEN.
This label is located on the top of the internal drive unit enclosure.
Dieses Etikett befindet auf der Gehäuseoberseite des internen Laufwerks.
DANGER
DANGER
VORSICHT
ADVARSEL
ADVARSEL
VARNING
VAROI
INVISIBLE LASER RADIATION WHEN OPEN.
AVOID DIRECT EXPOSURE TO BEAM.
RADIATIONS INVISIBLES DU LASER EN CAS D'OUVERTURE.
EVITER TOUTE EXPOSITION DIRECTE AU FAISCEAU.
UNSICHTBARE LASERSTRAHLUNG, WENN ABDECKUNG GEÖFFNET.
NICHT DEM STRAHL AUSSET ZEN.
USYNLIG LASERSTRÅLING VED ÅBNING.
UNDGÅ UDS/ETTELSE FOR STRÅLING.
USYNLIG LASERSTRÅLING NÅR DEKSEL ÅPNES.
UNNGÅ EKSPONERING FOR STRÅLEN.
OSYNLIG LASERSTRÅLING NÅR DENNA DEL AR ÖPPNAD.
STRÅLEN ÄR FARLIG.
NÄKYMÄTÖN AVATTAESSA OLET ALTTINA LASERSÄTEILYLLE.
ÄLÄ KATSO SÄTEESEN.
This CD-R/RW drive unit is classified as a CLASS 1 LASER PRODUCT. The CLASS 1
LASER PRODUCT label is located at the top of the internal drive unit enclosure.
Bei diesem CD-R/RW-Laufwerk handelt es sich um ein Laser-Produkt der Klasse 1. Das
Etikett mit der Aufschrift LASER KLASSE 1 PRODUKT befindet sich auf der
Gehäuseoberseite des internen Laufwerks.
CLASS 1
LASER PRODUCT
LASER KLASSE 1
PRODUKT
FCC Compliance:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note:
If you have any questions about this product, you may call the telephone number listed on
the “Product Support Information” page. The telephone number below is not for customer
service but only for official purpose.
Declaration of Conformity
Trade Name:
SONY
Model No.:
CRX1650L
Responsible Party: Sony Electronics Inc.
Address:
680 Kinderkamack Road, Oradell, NJ 07649 USA
Telephone No.:
201-930-6972
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
The shielded interface cable recommended in this manual must be used with this equipment
in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of
FCC Rules.
LOUKAN 1 LASERLAITE
KLASS 1 LASER APPARAT
