13
GB
Continued
Connecting to a Desktop Computer
Connect the USB cable from your camera to the USB connector on the
desktop computer.
You can connect or disconnect your camera to or from the desktop
computer while the computer is powered on. For details on the location
of the USB connector, please see the instruction manual for the
desktop computer.
Detaching the Camera
Note
• If you detach your camera while the computer is powered on, be sure to perform the
following procedures. If this is not performed correctly, there is a risk that the
computer may fail to operate correctly.
• When you detach the camera while the computer power is off, step 1 is not required.
However, when the USB cable is disconnected with the computer in the power saving
mode, the system may not recognize the camera if the USB cable is plugged in again.
1
Close the software used with your camera.
2
Unplug the USB cable.
Note
• Unplugging by grasping a part of the cable may result in damage.
Be sure to hold the connector section when unplugging.
• When removing your camera from the attachment adapter, widen the arm plate using
your fingers while detaching the camera.
