Sony CFI-1118A, Руководство по безопасности

Страница: 7 / 52

7
EN
Moisture condensation
If the console or disc is brought directly from a cold location to a warm one, moisture
may condense either on the lens inside the console or on the disc. Should this occur, the
console may not operate properly. In this case, remove the disc and turn off and unplug
the console. Do not put the disc back in until the moisture evaporates from the console
(this may take several hours). If the console still does not operate properly, contact
Customer Service Hotline.
Install an M.2 SSD
M.2 SSD is storage that uses flash memory. Install a commercially available M.2 SSD in
your PS5 console for more storage for your game and app data.
Types of M.2 SSD
You can use an M.2 SSD with the following specifications:
Interface
PCI-Express Gen4x4 supported M.2 NVMe SSD (Key M)
Storage 250 GB - 4 TB
Supported sizes 2230, 2242, 2260, 2280, 22110
Size including heat-dissipation
mechanism
Width: up to 25 mm
Length: 30/42/60/80/110 mm
Thickness: up to 11.25 mm (up to 8.0 mm from above the
board, up to 2.45 mm from below the board)
Notices
• Both single-sided devices and double-sided devices are supported.
• M.2 SATA SSD is not supported.
• Allocation of host memory to HMB (Host Memory Buffer) supported devices is not
supported.
• Carefully review drive specifications prior to purchase and contact the vendor or
manufacturer if you need further information. SIE cannot guarantee that all M.2 SSD
devices meeting the specifications above will work with your console and assumes no
responsibility for the selection, performance or use of third-party products.
About M.2 SSD heat-dissipation
The M.2 SSD that can be used with this device has a fast transfer speed and is therefore
subject to reaching high temperatures. If the M.2 SSD does not include a heat-
dissipation mechanism, attach a heat conductor, such as a heat sink, a heat transfer
sheet, or both. For information on how to attach the heat conductor, refer to its manual.
If you use your device without heat-dissipation parts, or the heat-dissipation parts come
off during use, the main unit may overheat, and continued use may cause operation
failure.