18
Error displays/Message
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna control lead (blue)
or accessory power supply lead (red) to the
power supply lead of a car’s antenna booster.
(Only when your car has built-in FM/AM
antenna in the rear/side glass.)
• Check the connection of the car antenna.
• The auto antenna will not go up.
t
Check the connection of the power
antenna control lead.
• Check the frequency.
Automatic tuning is not possible.
• The local seek mode is set to “ON.”
t
Set the local seek mode to “OFF”
(page 11).
• The broadcast signal is too weak.
t
Perform manual tuning.
The “ST” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t
Set the monaural reception mode to
“ON” (page 11).
A program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
t
Cancel monaural reception mode
(page 11).
Error displays
The following indications will flash for about 5
seconds (and in the case of “Err04”, an alarm
will be heard).
Err04
A CD is dirty or inserted upside down.
t
Clean or insert the CD correctly.
Err50
The connection of speakers/amplifiers is
incorrect.
t
See the installation guide manual of this
model to check the connection.
Err60
There may be an internal malfunction.
t
Check the connection. If the error
indication remains on in the display,
consult your nearest Sony dealer.
Err99
The CD unit cannot be operated because of
some problem.
t
Press the RESET button on the unit.
Message
“
” or “
”
You have reached the beginning or the end of
the disc and you cannot go any further.
