5
Getting Started
Canceling the DEMO
mode
You can cancel the demonstration display
which appears during turning off.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until “DEMO”
appears, then press it.
3
Rotate the control dial to select
“DEMO-OFF,” then press it.
The setting is complete.
4
Press
(BACK).
The display returns to normal reception/
play mode.
Setting the clock
The clock uses a 12-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until “CLOCK
ADJ” appears, then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press
–/+.
4
After setting the minute, press the
select button.
The setup is complete and the clock
starts.
To display the clock, press
.
Detaching the front panel
You can detach the front panel of this unit
to prevent theft.
1
Press and hold
.
The unit is turned off.
2
Press
.
3
Slide the front panel to the right, then
gently pull out the left end of the front
panel.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel,
the caution alarm will sound for a few
seconds. The alarm will only sound if the
built-in amplifier is used.
Note
Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a
parked car or on a dashboard/rear tray.
Attaching the front panel
Place the hole
of the front panel onto the
spindle
on the unit, then lightly push the
left side in.
Press
on the unit (or insert
a disc) to operate the unit.