11
Searching a track by listening to
track passages — ZAPPIN™
While playing back short track passages in a CD
or USB device in sequence, you can search for a
track you want to listen to.
ZAPPIN mode is suitable for searching for a
track in shuffle or shuffle repeat mode.
1
Press
(ZAP)
during playback.
After “ZAPPIN” appears in the display,
playback starts from a passage of the next
track.
The passage is played for the set time, then a
click sounds and the next passage starts.
2
Press the select button or
(ZAP)
when
a track you want to listen is played
back.
The track that you select returns to normal
play mode from the beginning.
To search a track by ZAPPIN mode again,
repeat steps 1 and 2.
Tips
•
You can select the playback time from about 6
seconds/9 seconds/30 seconds (page 18).You
cannot select the passage of the track to playback.
•
Press
(SEEK)
+/– or
(1)
/
(2)
(ALBM –/+) in ZAPPIN
mode to skip a track or album.
•
Pressing
(BACK) also confirms a track to
playback.
Radio
Storing and receiving stations
Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically — BTM
1
Press
(SOURCE/OFF)
repeatedly until
“TUNER” appears.
To change the band, press
(MODE)
repeatedly. You can select from FM1, FM2,
FM3, MW or LW.
2
Press and hold the select button.
The setup display appears.
3
Press the select button repeatedly
until “BTM” appears.
4
Press
(SEEK)
+.
The unit stores stations in order of frequency
on the number buttons.
A beep sounds when the setting is stored.
Storing manually
1
While receiving the station that you
want to store, press and hold a
number button (
(1)
to
(6)
) until
“MEM” appears.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.
Tip
When a RDS station is stored, the AF/TA setting is
also stored (page 12).
Receiving the stored stations
1
Select the band, then press a number
button (
(1)
to
(6)
).
Tuning automatically
1
Select the band, then press
(SEEK)
+/–
to search for the station.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
Tip
If you know the frequency of the station you want to
listen to, press and hold
(SEEK)
+/
–
to locate the
approximate frequency, then press
(SEEK)
+/
–
repeatedly to fine adjust to the desired frequency
(manual tuning).
ZAP
Select button
(BACK)
The part of each track to
playback in ZAPPIN mode.
Track
