5
Setting the clock
The clock uses a 24-hour digital indication.
1
Press and hold the select button.
The setup display appears.
2
Press the select button repeatedly
until “CLOCK-ADJ” appears.
3
Press
(SEEK)
+.
The hour indication flashes.
4
Rotate the volume control dial to set
the hour and minute.
To move the digital indication, press
(SEEK)
–/+.
5
Press the select button.
The setup is complete and the clock starts.
To display the clock, press
(DSPL)
. Press
(DSPL)
again to return to the previous display.
With the card remote commander
In step 4, to set the hour and minute, press
M
or
m
.
Tip
You can set the clock automatically with the RDS
feature (page 10).
Detaching the front panel
You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press
(OFF)
.
The unit is turned off.
2
Press
, then pull it off towards you.
Notes
•
Do not drop or put excessive pressure on the front
panel and display window.
•
Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
•
If the front panel is detached without turning off the
switch during playback by a USB device, data may
be damaged.
Attaching the front panel
Engage part
A
of the front panel with part
B
of
the unit, as illustrated, and push the left side into
position until it clicks.
Note
Do not put anything on the inner surface of the front
panel.
B
A
