Sony Bravia KDL-65W850A, Руководство по эксплуатации

Страница: 11 / 36

D:\SONY TV\SY130169_H34\4476177111_US\US03STU.fm
KDL-65W850A
4-476-177- 11 (1)
11
Getting Started
~
• If using an electric screwdriver, set the
torque at approximately 1.5 N·m
{15 kgf·cm}.
To detach the Table-Top Stand from the TV,
remove the screws
fixed in step 2.
~
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• Be sure the TV is vertical before turning on.
To avoid uneven picture uniformity do not
power on the TV with the LCD panel facing
down.
•
When installing the TV on a wall, remove the
screws from the rear of the TV. Be sure to
store the removed screws in a safe place,
keeping them away from children.
• When attaching the Table-Top Stand again,
be sure to fasten the screws (previously
removed) to the original holes on the rear of
the TV.
2: Connecting the TV
~
• Use an antenna cable connector no greater
than 14 mm thick.
• Use an HDMI cable connector within 12 mm
(thickness) × 21 mm (width).
• For more information on connections, refer to
the i-Manual.
x Shown with a Set Top Box with
HDMI connection
Recommendation of the F type plug
Projection of the inner wire from the
connection part must be less than 1.5 mm.
Detaching the Table-Top
Stand from the TV
Set Top Box
(Reference drawing of the F type plug)
1.5 mm max.
7 mm max.
(Continued)