Sony BDKP-N1001, Руководство по обслуживанию

Страница: 14 / 110

1-6 (E)
BDX-N1000
1-5. Replacing the Printed Circuit
Boards
1-5-1. IF-694 Board
Replacement Part
Part name : Mounted circuit board, IF-694
Part No. : A-8321-437-A
Replacement Procedure
1. Turn off the main power and remove the AC plug from
the outlet.
2. Remove the top panel. (Refer to Section 1-2-1.)
3. Remove the optional board. (Refer to Section 1-5-2 or
Section 1-5-3.)
4. Remove the four connectors (CN100, CN101, CN200
and CN1600) from the IF-694 board.
5. Remove the connector CN100 from the DP-270 board.
6. Remove the three nuts fixing the three BNC connec-
tors and the three toothed washers.
7. Remove the four bolts fixing the two D-SUB connec-
tors.
1-5. Replacing the Printed Circuit Boards
8. Remove the eight screws (PSW 3
x
6) and raise the
front side of the IF-694 board and remove it by pulling
it up at an angle.
n
The BNC connector is fitted with a ring that is not
secured. Be careful not to lose the ring when removing
the board.
9. Attach the new IF-694 board by reversing the disas-
sembly steps 8 to 4.
10. Attach the optional board. (Refer to the Installation
Manual.)
11. Return all the settings to those before the board was
replaced.
If the setup data has been backed up, download the
backup data to the new IF-694 board.
If the setup data was not backed up, use the Controller
Software and re-set all the settings.
(Refer to Section 1-6.)
n
If not all of the settings are returned to those before the
board was replaced, the BDX-N1000 may not operate
correctly.
The new IF-694 board is delivered with the default
setup when shipped from the factory. Be sure to return
all the settings to those before the board was replaced.
12. Return the switch of S600 (A-1) on the IF-694 board
to the setting before it was replaced.
13. Attach the top panel.
DP-270 board
CN100
CN100
CN1600
CN101
IF-694 board
Bolts
Nuts
Toothed
washers
CN200
Ring
BNC connector
PSW 3 x 6 PSW 3 x 6
PSW 3 x 6