ACC-TCV5
4-418-543-11(1)
Accessory Kit
Kit d’accessoires
Operating Instructions
Mode d’emploi
© 2012 Sony Corporation Printed in Japan
For a full charge, which allows you to use the battery pack longer than
usual, leave the battery pack in place for approximately another one
hour (
Full charge
).
To remove the battery pack
Remove the battery pack by sliding it in the opposite direction to when
you attached it.
Charging time
The following table shows the charging time for a battery pack that is
completely discharged.
“InfoLITHIUM” battery pack V series
Battery pack
NP-FV100
NP-FV70
NP-FV50
Normal
charging
time
900
490
240
“InfoLITHIUM” battery pack H series
Battery pack
NP-FH100
NP-FH70
NP-FH50
Normal
charging
time
900
410
205
“InfoLITHIUM” battery pack P series
Battery pack
NP-FP90
NP-FP71
NP-FP50
Normal
charging
time
620
410
160
For more about the battery life, see the instruction manual of your
ˎ
video camera.
The charging time may differ depending on the condition of the battery
ˎ
pack or the ambient temperature.
The times shown are for charging an empty battery pack which has
ˎ
been run down with a video camera, using this unit at an ambient
temperature of 25 °C (77 °F).
Charging temperature
The temperature range for charging is 0 °C to 40 °C (32 °F to 104 °F).
For maximum battery efficiency, the recommended temperature
range when charging is 10 °C to 30 °C (50 °F to 86 °F).
To use the battery pack quickly
You can remove the battery pack from this unit and use it even if
charging is not completed. However, the charging time affects the time
that the battery pack can be used.
Notes
If the CHARGE lamp does not light up, check if the battery pack is
ˎ
firmly attached to this unit.
When a fully charged battery pack is installed, the CHARGE lamp
ˎ
lights up once and then goes out.
A battery pack that has not been used for a long time may take longer
ˎ
than usual to charge.
The charged battery pack gradually discharges even if you do not use
ˎ
it. Charge the battery pack before use to avoid missing any recording
opportunities.
This unit supports worldwide voltages 100 V to 240 V.
Do not use an electronic voltage transformer, as this may cause a
malfunction.
Troubleshooting
When the CHARGE lamp blinks, check through the following chart.
The CHARGE lamp blinks in two ways.
Blinks slowly: Turns on and off repeatedly every 1.5 seconds
Blinks quickly: Turns on and off repeatedly every 0.15 seconds
The action to be taken depends on the way the CHARGE lamp blinks.
When the CHARGE lamp keeps blinking slowly
Charging is pausing. This unit is in the standby state.
If the room temperature is out of the appropriate temperature range,
charging stops automatically.
When the room temperature returns to the appropriate range, the
CHARGE lamp lights up and charging restarts.
We recommend charging the battery pack at 10 °C to 30 °C (50 °F to
86 °F).
When the CHARGE lamp keeps blinking quickly
When charging the battery pack for the first time in one of the
following situations, the CHARGE lamp may blink quickly.
If this happens, remove the battery pack from this unit, reattach it and
charge it again.
When the battery pack is left for a long time
When the battery pack is left installed in the camera for a long time
Immediately after purchase
If the CHARGE lamp keeps blinking quickly, check through the following
chart.
Please contact your nearest Sony dealer in connection with the product that may
have a problem.
Remove the battery pack that is being charged and then firmly attach the same
battery pack again.
The CHARGE lamp blinks again:
Install another battery pack.
The CHARGE lamp lights up and
does not blink again:
If the CHARGE lamp goes out
because the charging time has
passed, there is no problem.
The CHARGE lamp blinks again:
The problem is with this unit.
The CHARGE lamp lights up and
does not blink again:
If the CHARGE lamp goes out
because the charging time has
passed, the problem is with the
battery pack first installed.
Specifications
Battery Charger (BC-VH1)
Input rating
100 V - 240 V AC 50 Hz/60 Hz
6 VA - 10 VA 4 W
Output rating
Battery charge terminal:
8.4 V DC 280 mA
Operating temperature
0 °C to 40 °C (32 °F to 104 °F)
Storage temperature
–20 °C to +60 °C (–4 °F to +140 °F)
Dimensions (Approx.)
60 mm × 95 mm × 25 mm (w/h/d)
(2 3/8 in. × 3 3/4 in. × 1 in.)
Mass
Approx. 75 g (2.7 oz)
Rechargeable Battery Pack (NP-FV50)
Maximum output voltage DC 8.4 V
Mean output voltage
DC 6.8 V
Capacity (typ.)
7.0 Wh (1,030 mAh)
Capacity (min.)
6.6 Wh (980 mAh)
Operating temperature
0 °C to 40 °C (32 °F to 104 °F)
Dimensions
Approx. 31.8 mm × 20.5 mm × 45.1 mm
(w/h/d) (1 5/16 in. × 13/16 in. × 1 13/16 in.)
Mass
Approx. 51 g (1.8 oz.)
Included items
Battery Charger (BC-VH1) (1)
Rechargeable Battery Pack (NP-FV50) (1)
Set of printed documentation
Design and specifications are subject to change without notice.
Thank you for purchasing the Sony Accessory kit.
Battery Charger (BC-VH1)
Before operating this Battery charger, please read this manual thoroughly
and retain it for future reference.
Owner’s Record
The model and serial numbers are located on the bottom. Record the
serial number in the space provided below. Refer to these numbers
whenever you call upon your Sony dealer regarding this product.
Model No.
BC-VH1
Serial No.
WARNING
To reduce fire or shock hazard, do not expose the unit to rain or moisture.
Do not expose the batteries to excessive heat such as sunshine, fire or the
like.
To reduce the risk of fire or electric shock,
1) do not expose the unit to rain or moisture.
2) do not place objects filled with liquids, such as vases, on the apparatus.
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS.
DANGER - TO REDUCE THE RISK
OF FIRE OR ELECTRIC SHOCK,
CAREFULLY FOLLOW THESE
INSTRUCTIONS.
For connection to a supply not in the U.S.A., use an attachment plug
ˋ
adapter of the proper configuration for the power outlet, if needed.
This power unit is intended to be correctly orientated in a vertical or
ˋ
floor mount position.
The nameplate indicating operating voltage, power consumption, etc. is
located on the bottom.
Battery to be recharged for this product is follows
Brand Name
Sony
Battery Type
NP-FH50
Rating
(Typical Capacity)
DC 6.8 V
6.1 Wh
(900 mAh)
CAUTION
Use the nearby wall outlet (wall socket) when using this unit.
ˎ
Even when the CHARGE lamp of this unit is off, the power is not
disconnected. If any trouble occurs while this unit is in use, unplug it
from the wall outlet (wall socket) to disconnect the power.
Do not use this unit in a narrow space such as between a wall and
ˎ
furniture.
PRECAUTION
The set is not disconnected from the AC power source (mains) as long
as it is connected to the wall outlet (wall socket), even if the set itself has
been turned off .
NOTICE FOR THE CUSTOMERS IN THE U.S.A.
CAUTION
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
NOTE
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
ˋ
Increase the separation between the equipment and receiver.
ˋ
Connect the equipment into an outlet on a circuit different from that to
ˋ
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
ˋ
Notes on Use
This unit does not have dust-proof, splash-proof or water-proof
specifications.
Warranty for Recorded Content
Contents of the recording cannot be compensated if recording or
playback is not made due to a malfunction of the battery pack, battery
charger, etc.
Where not to place this unit
Do not place this unit in any of the following locations, whether it is in
use or in storage. Doing so may lead to a malfunction.
In direct sunlight such as on dashboards or near heating apparatus, as
ˎ
this unit may become deformed or malfunction
Where there is excessive vibration
ˎ
Where there is strong electromagnetism or radiant rays
ˎ
Where there is excessive sand
ˎ
In locations such as the seashore and other sandy areas or where dust
clouds occur, protect this unit from sand and dust. There is a risk of
malfunction.
Precautions on Use
Attach the battery pack firmly to this unit when charging the battery
ˎ
pack.
The battery terminal may be damaged if the battery pack is not
ˎ
attached correctly.
To protect the battery pack, remove it from this unit when charging is
ˎ
completed.
Do not drop or apply mechanical shock to this unit.
ˎ
Keep this unit away from TVs or AM receivers.
ˎ
Noise from this unit may enter a TV or radio if placed nearby.
Unplug this unit from the wall outlet (wall socket) after use. Hold this
ˎ
unit when you unplug it from the wall outlet (wall socket).
Be sure that nothing metallic comes into contact with the metal parts of
ˎ
this unit. If it does, a short may occur and this unit may be damaged.
The battery pack and this unit can become warm during or
ˎ
immediately after recharging.
Maintenance
If this unit gets dirty, wipe it using a soft dry cloth.
ˎ
If this unit gets very dirty, wipe it using a cloth with a little neutral
ˎ
solvent added, and then wipe it dry.
Do not use thinners, benzine, alcohol, etc., as they will damage the
ˎ
surface of this unit.
When you use a chemical cleaning cloth, refer to its instruction
ˎ
manual.
Using a volatile solvent such as an insecticide or keeping this unit
ˎ
in contact with a rubber or vinyl product for a long time may cause
deterioration or damage to this unit.
To Charge the Battery Pack
The battery pack is charged by attaching it to this unit.
* The battery pack illustrated is V series.
1
Attach the battery pack.
Keeping the battery mark
in the same direction as the charger mark
, insert the battery pack until it clicks into place. (See illustration
).
2
Pull the power plug up, and then connect it to a wall outlet
(wall socket).
Always connect the power plug with the prongs at the top (See
illustration
).
Do not connect the power plug with the prongs at the bottom (See
illustration
).
The CHARGE lamp (orange) lights up and charging begins.
When the CHARGE lamp goes out, normal charging is completed
(
Normal charge
).
The BC-VH1 battery charger can only be used to charge
ˎ
“InfoLITHIUM” battery packs (V series, H series and P series).
“InfoLITHIUM” V series, H series and P series battery packs have the
ˎ
,
, and
marks, respectively.
This unit cannot be used to charge a nickel cadmium type or nickel
ˎ
metal hydride type battery pack.
“InfoLITHIUM” is a trademark of Sony Corporation.
ˎ
Battery
mark
Battery
pack
Power plug
CHARGE lamp
Charger
mark
