62
Select this setting to set the transition time
and curve. See page 45 for details on using
the shot transition function.
x
TRANS TIME
Select transition time ([3.5 sec] to [15.0
sec] seconds, the default setting is [4 sec]).
x
TRANS CURVE
Select the transition curve. The transition
curve changes as follows.
*
1: parameter level
*
2: transition of time
LINEAR
Make the transition linearly.
B
SOFT STOP
Make the transition slowly at the end.
SOFT TRANS
Make the transition slowly at the
beginning and end, and linearly in
between.
b
Note
• You cannot change [TRANS TIME] and
[TRANS CURVE] settings during store, check,
or execution of [SHOT TRANS]. Cancel
[SHOT TRANS] setting by pressing the
ASSIGN button 1 several times before changing
[TRANS TIME] or [TRANS CURVE] setting.
You can record pictures with a stop-motion
animated effect by alternately recording a
few frames and then moving the subject a
little. Operate your camcorder using the
Remote Commander to prevent camera
shake.
B
OFF
Select to record in the standard recording
mode.
ON (
)
Select to record pictures using the DV
FRAME REC function.
1
Select [ON] by the SEL/PUSH EXEC
dial.
2
Press the MENU button to hide the
menu screen.
3
Press the REC START/STOP button.
A picture (approximately 6 frames) is
recorded, and your camcorder enters
the standby mode.
4
Move the subject and repeat step 3.
b
Note
• When you use frame recording continuously,
the remaining tape time will not be indicated
correctly.
• The last scene will be longer than other scenes.
• You cannot record index signals during frame
recording.
• This is automatically set to [OFF] if you turn the
power off and back on.
When you set [BACK LIGHT] to [ON],
.
is displayed and the back light function is
enabled (the default setting is [OFF]).
b
Notes
• The back light function is canceled when you
set [SPOTLIGHT] to [ON].
SHOT TRANS
*
1
*
2
*
1
*
2
*
1
*
2
DV FRAME REC
BACK LIGHT
Press the MENU button
t
select the
(CAMERA SET) by turning the SEL/PUSH EXEC
dial.
Содержание 1080i
Страница 131: ......
