17
Instructions
16
For Windows 3.xx don’t use the
32 bit hard disk access, because
this mode is not supported for
DVD drives.
If the reading function is availa-
ble the next step is to achieve
the writing function provided by
the writing software. Please
insert your writing software CD-
ROM into the DVD Writer and use
the information provided with
the software (if the installation
does not starting automatically
you have to activate the software
installation manually).
Support
For local support like hotline,
service or firmware updates please
check following Internet site:
http://www.sony-optiarc.eu
Emergency Eject*
The procedure described below
can be used to open the tray of
the Optiarc Writer if the EJECT
button is disabled by software or a
power failure occurs.
1
. Turn off the power to the
Slimline DVD Writer.
2
. If a disc inside still is spinning
wait until it stops.
3
. Insert a steel rod (about 0.8 mm
in diameter) into the emergency
eject hole and push firmly until
the cartridge is ejected. A stiff
paper clip may be used as steel rod.
*) the slot-in drives AD-7630,
AD-733 and AD-7670 do not
have a emergency eject hole
Driver Installation
The software installation starts
with activating the reading func-
tion of the drive (CD-ROM).
If you are using the Slimline DVD
Writer with Windows 95/98/ME/
NT/2000/XP or IBM OS/2 Warp,
all necessary drivers will be
loaded automatically by the
operating system.
Drivers mentioned above are part
of the Operating Systems and are
not available from Sony Optiarc.
To use the IDE/ATAPI Slimline
DVD Writer with MS-DOS and
MS-Windows 3.x, you have to
install the attached driver software
before you can use the Optiarc
Writer for the first time.
Refer to the README.TXT file on
the driver disk for information
about installing this driver.
This drive supports RPC according
to SFF8090v4 (RPC-2). The final
setting/definition of the video
region code is determined by the
fifth DVD video region code change.
20 mm
AD-5590A/S
AD-7590A/S
AD-7591S
AD-7593A/S
AD-7630A
, AD-7670S
AD-7633A
