Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
7(128)
2.1.3
Outer Base Cover Removal
All of the sections of the Base Disassembly preceding this section must be performed in
sequential order before the disassembly steps listed below can be performed.
Tools needed:
•
Pry Tool
•
Style 2A ESD tweezers (Blunt tip)
•
Torque screwdriver
•
Torx Plus size 5 bit
•
Front opening tool
Step-by-Step Instructions
NOTE! Be careful not to scratch the inner base
cover when removing the base’s screw
cover panel.
1.
Open the phone so that the main keypad is accessible
and locate the screw cover panel on the inner base
cover.
2.
Begin lifting the screw cover panel away from the
inner base cover by using the tip of one side of a pair
of style 2A tweezers or a front opening tool at one of
the two locations indicated.
3.
Once a portion of the screw cover panel is slightly
lifted, grip the lifted portion of the panel and peel it
off of the base.
NOTE! The screw cover panel cannot be reused.
4.
Carefully clean off any remaining adhesive residue
from the area on the inner base cover where the
screw cover panel mounts using the style 2A
tweezers, alcohol, and a lint free wipe.
5.
Remove the two screws that were concealed by the
base’s screw cover panel using a torque driver and a
Torx Plus size 5 bit.
