Sonotec 200 08 0001, Руководство по эксплуатации

Страница: 19 / 30

Operating Manual SONOFLOW IL.52 V2.0
11
Revision: 1.0; Date: 2018-10-26
4 Installation and commissioning
The SONOFLOW IL.52 V2.0 is intended as component to be integrated into devices or machines.
The sensor is mechanically and electrically incorporated into the customer control unit.
4.1 Attaching the Sensor SONOFLOW IL.52 V2.0
The geometric layout always determines flow characteristics in a fluid system. The sensor
accuracy depends among other things on the mounting position in the flow system.
Incorrect installation may have an impact on the measuring accuracy.
Depending on the application this can have unforeseeable consequences.

Mechanical vibrations can affect sensor functions. Ensure that the
mounting or the tubes (lines) do not transmit vibrations to the sensor.
Recommended is an installation position with a flow direction against the force of gravity.

Use the drilled holes on the rear side of the sensor to attach the sensor.
(For dimensions: see the Technical Data Sheet).

Connect the tubing with the sensor via the designated adaptors:

Outer diameter: 8 mm

Inner diameter: 4 mm

Connect the sensor to power supply via the M12 plug-in connector as described in the
“Technical Data Sheet”.
NOTE!
A shielding is not necessary but recommended for long lines (> 30 m)
or in harsh industrial environments.
If pins at the connector are not used, they should be covered to protect
them against moisture and contamination
Use the service interface only in conjunction with the SONOFLOW Monitor
(optional accessory).