4 Standalone Operation
4.1
Powering the SX-AD8+
The SX-AD8+ operates as soon as the input DC voltage is applied, there is no power
switch button.
Once powered, the SX-AD8+ operates immediately as it was on last power down.
To operate in standalone mode, the WIFI should be switched OFF to save power.
4.2
Input Configuration
In standalone mode, device configuration is done using input gain push-buttons and
LEDs.
To configure an input, apply a long press to the selected input gain knob until selected
input LED blinks (in red).
POWER
48V
+20dB PHASE
OFF
60Hz
120Hz
LOW FREQ CUT FILTER
UNUSED
When input configuration is enabled, knobs and LEDs 1 to 7 are used to change input
setup:
1 – INPUT POWER
LED off: input OFF
LED green: input powered
2 – PHANTOM POWER 48V
LED off: no phantom power
LED green: 48V phantom power
3 – INPUT GAIN +20 dB
LED off: input gain 0 dB
LED green: input gain +20 dB
4 – PHASE REVERSAL
LED off: input phase normal
LED green: input phase reversed
5, 6, 7 – LOW FREQUENCY CUT
FILTER (LF CUT)
LED 5 green: LF CUT disabled
LED 6 green: LF CUT 60 Hz
LED 7 green: LF CUT 120 Hz
LEDs 5-7 are mutually exclusive
To exit input setup, apply a long press to any input gain knob.
SX-AD8+ User Manual
7/19
